Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.1 Switching on
Place the plug in the wall socket and switch the device on as follows:
•
Press 1 on the green switch, the light will now come on. The display will perform a self-test till the
interior temperature is measured.
•
After the device starts up (compressor switches on), the light (B) will come on, this will go off again when
the compressor stops.
•
The temperature is automatically regulated by the electronic thermostat.
•
During defrosting light A will come on.
•
During normal use the display will show the room temperature. The LED lights show the operation of
the compressor, defrost cycle or warning message.
•
Press C for 3 seconds to start a manual defrost cycle.
5.2 Set temperature
Adjusting the set temperature:
•
Briefly press the Set key.
•
Within 15 seconds you can adjust the set values with the ^ and v keys.
•
Subsequently press SET again within 10 seconds to save the value in the memory.
•
The newly set value will not flash for 2 seconds, this means that the value is saved.
•
Normally the set value is 4 degrees.
5.3 Defrosting (manual)
The device defrosts automatically, the controller automatically switches the defrosting on and off. Manual
defrosting is also possible. If necessary (icing on the evaporator) it is possible to start an additional defrost cycle
(outside the program) by pressing button C for 3 seconds, then the defrost program will start automatically. Do
not unnecessarily open the door after a defrost cycle so the temperature in the cooling area can be reached
quicker.
5.4 Cleaning the storage area
The storage area, the outside and all accessories of the device must be cleaned with warm water and a neutral
detergent, subsequently clean all parts with clean water and then dry them. Do not use any aggressive detergents
or abrasives.
To achieve a perfect hygiene and conservation daily cleaning is recommended, which means:
•
Clean the surfaces every day with a slightly damp cloth.
•
Always use water with a neutral detergent, avoid chlorine-based detergents and/or detergents
containing abrasives.
•
Rinse with clean water and carefully dry everything.
•
Do not use water under pressure in the direction of the compressor.
•
Avoid the use of tools that can causes scratches on the device.
•
Make sure there are no leftovers that can block the drain of the condensate container.
www.combisteel.com
8
Publicité
Table des Matières
