Ribimex PRGES2000I Mode D'emploi page 49

A dirty air filter limits the air flow to the carburetor. To prevent malfunction of the carburetor,
regularly clean the air filter. Check and clean more often when the generator is used in dusty areas.
Using a flammable solvent or gasoline to clean the air filter can result in a fire or
explosion. Only use soapy water or a non-flammable solvent.
Note: Running the engine without an air filter or a damaged filter will allow dirt to enter the engine
and cause rapid engine wear. This type of damage is not covered by the warranty.
(1) Unscrew the 5 screws and remove the engine maintenance compartment (1).
(2) Unscrew the screw (2) and remove the air filter cover (3).
(3) Wash the foam (4) in a solution of household detergent and warm water, then rinse thoroughly.
Or wash in a non-flammable solvent. Allow to dry well.
(4) Replace the foam (4) and the air filter cover (3) and tighten the cover screw (2).
(5) Replace the engine maintenance cover (1) and tighten the 5 screws securely.
6.2.3- Spark plug maintenance (Fig. 23)
Recommended spark plug: A5RTC (TORCH). For proper motor operation, the
spark plug electrodes must be removed properly and without deposit. Using an
unsuitable spark plug can cause engine damage. Allow the engine to cool before
servicing.
(1) Unscrew the screw (5) then remove the maintenance compartment from the spark plug.
(2) Remove the spark plug cap (2).
(3) Use a spark plug wrench (4) to remove the spark plug (3).
(4) Inspect the spark plug. Replace it if the electrodes are worn out or if the insulator is cracked,
crumbled or soiled.
(5) Measure the electrode gap with a feeler gauge. The spacing should be 0.6 to 0.7mm.
(6) Check the spark plug sealing washer and check that it is in good condition.
- 46 -