Ribimex PRGES2000I Mode D'emploi page 48

to follow this maintenance schedule could result in non-warrantable failures.
6.2- Specific Maintenance
6.2.1- Engine oil (Fig. 21)
Drain the oil when the engine is still hot, the hot oil will flow quickly and easily.
(1) Close the fuel valve, close the cap securely and place the breather valve in the OFF position to
reduce the risk of leakage.
(2) Open the oil maintenance compartment (1).
(3) Place a suitable container (3) near the engine to collect used oil.
(4) Unscrew and remove the dipstick (2), use an A4 sheet and make it a roll with a diameter of about
30mm.
(5) Put the paper roll (4) outside of the filler neck (5) and drain the used oil into the container (3) by
tilting the motor towards the filler neck (5).
(6) With the engine level, fill with recommended oil to the upper limit through the filler neck (5).
(7) Screw in the dipstick (2) and make sure that it is correctly and firmly tightened.
(8) Replace the oil maintenance cap (1).
6.2.2- Air filter maintenance (Fig. 22)
- 45 -