Installation Planning; Location And Clearances - Napoleon HIGH COUNTRY 5000 Serie Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
!
Wear gloves, protective footwear and safety glasses for protection.
Carefully follow the instructions for assembly of the pipe and other parts needed to install the appliance.
Failure to do so may result in a fi re, especially if combustibles are too close to the appliance or chimney and air
spacers are blocked, preventing the free movement of cooling air.
Do not draw outside air from garage spaces. Exhaust products of gasoline engines are hazardous. Do not
install outside air ducts such that the air may be drawn from attic spaces, basements or above the roofi ng
where other heating appliances or fans and chimneys exhaust or utilize air. These precautions will reduce the
possibility of appliance smoking or air fl ow reversal. The outside air inlet must remain clear of leaves, debris, ice
and/or snow. It must be unrestricted while appliance is in use to prevent room air starvation which can cause
smoke spillage and an inability to maintain a fi re. Smoke spillage can also set off smoke alarms.
Negative pressure within your home may inadvertently affect your appliance.
To prevent contact with sagging or loose insulation, the appliance must not be installed against vapour barriers
or exposed insulation. Localized overheating could occur and a fi re could result.
Do not use makeshift compromises during installation. Do not block or restrict air, grille or louvre openings. Do
not add a hood.
To prevent personal injury, keep hand tools in good condition, sharpen cutting edges and make sure tool
handles are secure.
Always maintain the minimum air space required in the enclosure to prevent fi res.
Check with local building offi cials for any permits required for installation of this appliance and notify your
insurance company prior to proceeding.
note:
The enclosure must be ventilated, see "framing" section.
3.1

location and clearances

WARNING
!
Do not install into any area having a height less than 7 feet (2.1m) (ceiling of enclosure to appliance
bottom, excluding hearth height).
IMPORTANT
This appliance, fully dressed, weighs 745lbs (338kg). Ensure there is adequate floor support for the appliance,
chimney and facing material. Some material could weigh thousands of pounds.
We recommend that the appliance be secured to the floor in all cases.
Using the door opening as a datum, level
the appliance by shimming underneath the
appliance. Using the pallet securing tabs on
the front corners and rear (not illustrated),
secure the appliance to the floor.

3.0 installation planning

Securing tab x3
installation planning
42.3
W415-1720 / G / 05.14.21
EN
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

High country nz5000-tHigh country nz5000

Table des Matières