Installation And Replacement - Napoleon HIGH COUNTRY 5000 Serie Manuel D'installation

7.1 firebrick installation
WARNING
!
• Risk of fire! Operation of the appliance without the firebricks can result in excessive temperatures that will
damage the appliance, chimney and the surrounding enclosure.
note:
Ensure fibre panels set in behind brick are in good condition before installing firebrick. If fibre panels need to
be replaced, hold panels in position or secure with masking tape until firebrick is installed.
Proper Installation of Side Panels:
Side panels will have two distinct angles on either side of each panel. The shallow angle should face the outside of the
appliance. The steeper angle should face to the inside of the appliance and will match to the adjacent panel.
1. Tilt and install the right
and left rear firebrick
against the wall with
cutouts towards the front.
Pull towards the front of
the appliance.
4. Install the middle top rear
firebrick.

7.0 installation and replacement

installation and replacement
2. Install the bottom firebricks
and pull forward until rear
brick is installed.
5. Position the two side
and back fiber panels
(shipped inside the
appliance box), then
secure with the retaining
brackets supplied.
3. Tilt and install the bottom
rear firebrick against the
wall.
6. Using the screws supplied
secure andirons (shipped
in appliance box) in place.
W415-1720 / G / 05.14.21
EN
29