Polaris VICTORY MOTORCYCLES HAMMER 2010 Mode D'emploi page 90

Maintenance
Rear Suspension
Rear Shock Preload (Ride Height) Adjustment
1. Rest the motorcycle on the sidestand. Remove the right
side cover. See page 42.
2. Remove the fuse box. See page 118. Make sure the rear
brake fluid reservoir cap is secure to prevent fluid loss.
3. Remove the three 10 mm bolts securing the fuse box
bracket to the chassis.
4. Remove the on-board diagnostics connector from the
fuse box bracket by squeezing the connector lock and
pulling the connector apart. Leave the terminated end
attached to the fuse box bracket.
5. Remove the wire harness dart from the fuse box
bracket by sliding the connector off the dart clip.
6. Carefully pull and rotate the fuse box bracket toward
the front of the motorcycle.
88
10 mm Bolts