Polaris VICTORY MOTORCYCLES HAMMER 2010 Mode D'emploi page 103

Clutch (Hydraulic)
Hydraulic Clutch Fluid
Check the hydraulic clutch fluid level. See page 54. The fluid level should be at or
above the top of the sight glass. Add fluid as needed. Replace cloudy or contami-
nated fluid.
Use DOT4 brake fluid in the hydraulic clutch reservoir. Use fluid only from a sealed,
clean container.
Do not operate the clutch while the reservoir cover is removed. Fluid could overflow
from the reservoir and cause air to enter the fluid system.
WARNING! Using the wrong fluid or allowing air or contaminants into the fluid system can
damage the system seals or result in a malfunction that could lead to serious injury or death.
1. Straddle the motorcycle and bring it to the fully upright position. Position the
handlebars so that the fluid reservoir is level.
2. Wipe the fluid container and the area around the reservoir cover with a clean
cloth.
3. Remove the reservoir cover and gasket.
4. Carefully add fluid to the recommended level.
5. Reinstall the reservoir gasket and cover.
Maintenance
Minimum
Level
Clutch Fluid Sight Glass
101