Starter Button - Polaris VICTORY MOTORCYCLES HAMMER 2010 Mode D'emploi

Instruments, Features and Controls
Right Handlebar Controls
Engine Stop/Run Switch
The engine stop/run switch completes or inter-
rupts the ignition, starter and fuel pump circuits.
To complete the circuits, allowing the engine to
start and run, press the lower portion of the
engine stop/run switch (RUN position). To
interrupt the circuits, press the upper portion of
the switch (STOP position). The engine should
not start or run when the switch is in the STOP
position.
Use the engine stop/run switch to turn the
engine off under either normal or emergency
conditions.
38

Starter Button

The starter button works only when the engine
stop/run switch is in the RUN position and the
transmission is in neutral or the clutch is disen-
gaged (lever pulled in toward handlebar.) To
engage the engine starter motor, press the right
side of the starter button.
For complete engine starting procedures, see
page 60.
Starter Button
Stop/Run
Switch