Polaris VICTORY MOTORCYCLES HAMMER 2010 Mode D'emploi page 121

Headlight Aim Inspection
Bullet Headlights: The top edge of the high beam must be 3 inches (7.6
cm) below the height of the headlight housing parting line and centered
straight ahead at 25 feet (7.6 m).
Round Headlights: The top edge of the low beam must be at the same
height as the center of the headlight lens and centered straight ahead at
25 feet (7.6 m).
1. Verify that tire pressure is at specification. See page 108.
2. Verify that rear suspension ride height (preload) is at specification.
Include rider, passenger (if applicable) and cargo when setting
preload. See page 86.
3. Position the motorcycle on a level surface with the headlight 25 feet
(7.6 m) from a wall.
4. With the operator and passenger (if applicable) on board, bring the
motorcycle to the fully upright position.
5. Move the ignition switch to the ON position and switch the
headlamp to high beam. Observe the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim.
Maintenance
Bullet Headlight High Beam
25 ft. (7.6 m)
3 in. (7.6 cm)
Height of headlamp
housing parting line
Round Headlight Low Beam
25 ft. (7.6 m)
Height of center
of headlamp lens
119