Chargers; Charging Process - Stanley ProSet PB3400 Traduction Des Instructions Originales

Masquer les pouces Voir aussi pour ProSet PB3400:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PB3400 (fi g. 4 & 5)

Select the correct jaw pusher assembly (R) and Mandrel guide (AA) that matches the Nose Piece selected.
Reference the Accessories Manual for appropriate nose equipment.

Insert mandrel guide (AA) into pulling head (T)

Insert jaw pusher asembly (R) into jaw pusher spring (S)

Reassemble jaw set (Q) and jaw guide (P) onto Pulling head (T)
NOTE: Do NOT use spanners to mount jaw guide (P) onto front clutch or jaw case lock (U). Manual tightening
of Jaw guide (P) is enough to lock onto front clutch or jaw case lock (U)

4.2. CHARGERS

Your tool uses a DEWALT®/POP® Avdel® charger. Be sure to read all safety instructions before using your
charger. The charger requires no adjustment and is designed to be as easy as possible to operate.
Charging Procedure (fi g. 2)

Plug the charger into an appropriate outlet before inserting the battery pack. (Refer to the Charger
Specifi cations in Section 2)

Insert the battery pack (K) into the charger, making sure the pack is fully seated in the charger. The red
(charging) light will blink continuously indicating that the charging-process has started.

The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
NOTE: To ensure maximum performance and life of Li-Ion battery packs, charge the battery pack fully before
fi rst use.

Charging Process

Refer to the table below for the state of charge of the battery pack.
Charge indicators:
charging
fully charged
hot/cold pack delay*
*The red light will continue to blink, but a yellow indicator light will be illuminated during this operation. Once
the battery has reached an appropriate temperature, the yellow light will turn off and the charger will resume
the charging procedure.
This charger will not charge a faulty battery pack. The charger will indicate faulty battery by refusing to light.
NOTE: This could also mean a problem with a charger.
If the charger indicates a problem, take the charger and battery pack to be tested at an authorised service
centre.
E N G L I S H
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Proset pb2500

Table des Matières