Publicité
Les langues disponibles
Les langues disponibles
39
WarminG
1. Check the device to make sure that there is no visible damage that may
affect user's safety and measurement performance. Stop using the unit,
when there is obvious damage.
2. Stop using the ECG cable if it is damaged, please change a new one.
3. Do NOT make diagnosis oneself by the measurement and measurement
results, always consult the doctor if abnormal information is presented
frequently.
4. It is NOT designed or intended for medical diagnosis.
5. It is NOT designed or intended for therapy purpose.
6. Do NOT use the device in the bathroom or moist circumstance.
7. Do NOT operate in the environment where strong electro-magnetic
interference exists.
8. Necessary service must be performed by qualified service engineers
ONLY.
9. Clinical ECG examination is suggested for normal examination
of your heart condition.
10. Connect/Disconnect data cable to the monitor gently and carefully,
do NOT wring or shake the data cable plug with force to insert into
or unplug from data interface port, or the data interface port may be
damaged.
11. When the ECG amplifier is overload or saturation due to lead off or poor
contacts between electrode and the skin, the monitor will prompt
"Contact?" to remind the operator.
12. Do not touch the metal electrodes or place the electrodes of lead wire
on patient for ECG measurement while the USB cable is connected
to PC, electrical hazard will be caused by the leakage current.
13. ECG electrodes, lead wires and cable are not allowed to contact
any other conductive parts.
14. It is strongly recommended to use Ag /AgCl (Silver Chloride) electrode
to make sure the ECG signal quality is good.
15. Dispose of the expired device and its accessories according
to applicable local regulations.
ENGLISH
Publicité
Chapitres
