Lenze starttec type1 Instructions De Montage page 102

7
Commissioning
With hand terminal
The user menu is set to all codes at the factory to allow for commissioning a standard application:
)
Note!
Settings for "Motor 2" are not relevant for the starttec "Motor starter
type 1"! (Corresponding information applies only to the starttec "Motor
starter type 2" for operation with 2 motors.)
Code Designation
C0054 Apparent motor current of
motor 1
C0055 Apparent motor current of
motor 2
C0006 Transfer HW/hand terminal
C0120 Rated current
1 Motor 1
2 Motor 2
C0410 Configuration of digital input
signals
1 Motor 1 start/stop
2 Motor 2 start/stop
3 Brake control
4 ... 24
C0415 Configuration of digital
output signals
1 X3/A1
2 X3/A2
3 X3/A3
4 X3/A4
5 ... 6 AS−I output bit
C0012 Motor voltage acceleration
time
1 Motor 1
2 Motor 2
C0423 Delay time of "Release
brake"
C0424 Delay time of "Apply brake"
C0002 Parameter set management
102
Lenze setting
Display only
Display only
0 Setting the acceleration time (C0012) and starting voltage
(C0016) via potentiometer, setting the rated motor current
(C0120) via stepping switch
Rated motor current for I
Accepts the value from the stepping switch:
l If C0006 = 0, 2, 4, 6:
– Display only
If C0006 = 1, 3, 5, 7:
l
– Rated current can be set via C0120
1 X3/E1
2 X3/E2
3 X3/E3
255 Not assigned
3 Status of motor 1
4 Status of motor 2
5 Status of brake
25 TRIP error message
255 Not assigned
Time for voltage change U
Accepts the value from potentiometer "T"
l If C0006 = 0, 1, 2, 3:
– Display only
If C0006 = 4, 5, 6, 7:
l
– Acceleration time can be set via C0012
0.00 s
0.00 s
See code table
EDK71MMXXX−010 DE/EN/FR 5.0
2
t monitoring
... U
0 mains
L