Lenze starttec type1 Instructions De Montage page 95

Control of starttec with PROFIBUS−DP FIF module
The control of starttec via PROFIBUS−DP FIF module is possible via control word FIF−CTRL1 and status
word FIF−STAT1.
The following bit assignment applies:
Bit Assignment of control word FIF−CTRL1
0 S1
1 S2
2 Reserved
3 Reserved
4 Reserved
5 Reserved
6 Reserved
7 Reserved
8 Reserved
9 Controller inhibit (FIF−CTRL1−CINH)
0 = controller released
1 = controller inhibited
10 External fault (FIF−CTRL1−TRIP−SET)
11 Reset fault (FIF−CTRL1−TRIP−RESET)
0 = a bit change causes TRIP reset
12 Reserved
13 Reserved
14 Reserved
15 Reserved
L
Electrical installation
Connection of bus function module
Assignment of status word FIF−STAT1
Reserved
Pulse inhibit (DCTRL1−IMP)
0 = power outputs released
1 = power outputs inhibited
Reserved
Reserved
Reserved
Reserved
Fixed 1
Controller inhibit (DCTRL1−CINH)
0 = controller released
1 = controller inhibited
Device status (DCTRL1−STAT*1 ... DCTRL1−STAT*6)
0001 = switch−on inhibit
0011 = operation inhibited
0110 = operation released
1000 = fault active
Reserved
Reserved
Reserved
Ready for operation (DCTRL1−RDY)
0 = not ready for operation (fault)
1 = ready for operation (no fault)
EDK71MMXXX−010 DE/EN/FR 5.0
5
95