Front Panel; Speaker System (X-Hm70 Only) - Pioneer X-HM70-S Mode D'emploi

Controls and Displays
Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the
unit. The remote control can be used within the range shown
below:
Remote sensor
TIMER
7 m
STANDBY/ON

Front Panel

1 2 3
6
TIMER
7
8 9 10 11 12 13 14 15
1 Remote Sensor
Receives the signals from the remote control.
2 Timer Indicator
Lights when the timer is set (page 26).
3 Disc Tray
Place the disc, label side up (page 13).
4 iPod or iPhone Docking Station
Dock iPod/iPhone (page 17).
5 Volume Control
Use to set the listening volume (page 11).
6 STANDBY/ON Button
Switches the receiver between standby and on (page 11).
7 INPUT Button
Selects the input source (page 12).
8 Headphone Socket
Use to connect headphones. When the headphones are
connected, there is no sound output from the speakers
(page 12).
9 AUDIO IN Socket
Use to connect an auxiliary component using a stereo
minijack cable (page 12).
10 USB Terminal
Use to connect your USB mass storage device or Apple iPad
as an audio source (page 19).
11 Tune Down, Skip Down Button
Selects the desired track or folder to be played back.
4
12 Tune Up, Skip Up Button
Selects the desired track or folder to be played back.
5
13 Stop Button
Use to stop the playback.
14 Play or Pause Button
Stops playback or resumes playback from the pause point.
15 Disc Tray Open/Close Button
Use to open or close the disc tray (page 13).

Speaker system (X-HM70 only)

1 Dome-Tweeter
2 Woofer
3 Bass Reflex Duct
4 Speaker Terminal
Speaker grilles are removable
Make sure nothing comes into contact
with the speaker diaphragms when you
remove the speaker grilles.
3
1
4
2
7
En