Installation; Mounting The Sensor; Connection; Connecting The Inpro 6900 To A Vp Cable - Mettler Toledo InPro 6900 Série Instructions D'utilisation

14
4

Installation

4.1

Mounting the sensor

Important! Remove the watering cap before mount ing
the sensor.
Mounting the sensor in a housing
Please refer to the instruction manual of your housing
explaining on how to mount the sensor in place.
Mounting the sensor directly on a pipe or a vessel
The 12 mm sensors can be mounted directly through
a socket with inside thread Pg 13.5 and securely tight-
ened via the Pg 13.5 threaded sleeve.
15°
4.2

Connection

4.2.1 Connecting the InPro 6900 to a VP cable

Sensors with ISM functionality require the use of a spe-
cial VP-8 cable as well as an ISM-compatible O
mitter. The sensor is connected to the transmitter via a
VP cable. The VP cable ensures a secure connection
between the transmitter and the sensor under harsh in-
dustrial conditions. The robust watertight IP68 connec-
tor housing guarantees maximum process safety.
If you have chosen to use a sensor with ISM function-
ality, the VP connector will incorporate an EEPROM
chip. It is absolutely necessary to protect this electron-
ic component against any electrical charge.
Do not touch the sensor at the VP connector plug.
To connect the VP cable to the sensor align the slit of
the VP connector with the pin in the plug. Then tightly
screw the plug to fasten the two parts.
InPro 6900
52 201 029
InPro 6900 Series O
Admissible mounting position
Zulässige Einbaulage
Positionement de montage admis
52910094ME
Inadmissible angle
Unzulässiger Winkel
Angle non admissible
Sensor 12 mm
2
© 05 / 15 Mettler-Toledo AG
Printed in Switzerland
15°
trans-
2