Sensor Installation - Mettler Toledo InPro 86X0i Guide D'installation Rapide

InPro 86X0 i
Example label
MODEL
型号：浊度传感器
P/N:
30421361
S/N:
1752001
1.4404/316L
PS:16 bar
TS:120 °C
Cable connection to M800 Process 1-Channel transmitter
The RS-485 data cable (5-pin) is available from METTLER TOLEDO
in various lengths. Connect the data cable to the M800 Process
1-Channel transmitter as described below.
M800 Process 1-Channel TB3
Terminal
1
2
3
4
5
6
7
8
9 – 16
In order to ensure optimum measurement results the follo-
wing points must be considered:
– Run the connection cable through the cable gland.
– Connect the wires to the sensor.
– Hand-tighten the cable gland.
4

Sensor Installation

The sensor is equipped with a Tuchenhagen-Varivent process
adapter, which is used to attach the sensor to the process
pipe in dimensions from DN 40 to DN 150. Prior to the in-
stallation, the sealing surfaces (sensor and pipe adapter)
need to be cleaned and checked for damages. Further, it
needs to be verified that no obstacles are present within the
installation cavity of the sensor.
The installation of the sensor should be in a vertical stand-
pipe. If the sensor will be installed in a horizontal pipe, it
must be in a horizontal position and the process pipe has
to be filled completely with liquid during the measurement.
Installation on a vertical line (preferred)
© 03 / 18 Mettler-Toledo GmbH
Turbidity Sensor InPro8630i
：
InPro8630i
0036
METTLER TOLEDO
www.mt.com/pro
梅特勒
地址：上海市桂平路
邮编：
Mettler-Toledo GmbH
Im Hackacker 15
8902 Urdorf,Switzerland
Function 5-pin cable wire color
1-Wire –
GND5V Yellow
RS485B Blue
RS485A White
GND5V Grey
5V –
24V Brown
GND24V Black
Not used –
19
- ( )
托利多仪器 上海 有限公司
589 号
200233
Made in China by
METTLER-TOLEDO
InPro 86X0 i
30 421 373 A
en