Squeegee Cleaning - Viper AS5160 Manuel Utilisateur

USER MANUAL

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must
be in good conditions in order to get a good
drying.
CAUTION!
It is advisable to wear protective gloves when
cleaning the squeegee because there may be
sharp debris.
1. Drive the machine on a level floor.
2. Turn the ignition key (A, Figure17) to "0".
3. Lower the squeegee (B) with the lever (C).
4. Loosen the knobs (D) and remove the squeegee (B).
5. Disconnect the vacuum hose (E) from the squeegee.
6. Clean the steel or the aluminum squeegee (Figure18). Clean
the compartments (A) and the hole (B) especially. Check
the front blade (C) and the rear blade (D) for integrity, cuts
and tears; if necessary replace them (see the procedure in
the following paragraph).
7. Assemble the squeegee in the reverse order of disassembly.
A
21
ENGLISH
B
D D
Figure 17
A
B
A
D
C
Figure 18
C
E