Machine Start And Stop; Starting The Machine; Stopping The Machine - Viper AS530R Manuel D'utilisation

USER MANUAL

Brake unstuck -the brake handle(D, Figure 9) locates above

Brake locked –the brake handle locates lower
In some special cases, such as machine packing/unpacking,
machine fault etc., need to move the machine without drive
motor working, please manually set the brake to unstuck
status to move it.
To avoid any security risk, ensure to set the brake back to
locked status after machine movement.

MACHINE START AND STOP

Starting the machine

1. Prepare the machine as shown in previous paragraph.
2. Sit on the seat (L, Figure 10), insert the key switch (A) and turn
it to "ON". If the green light (C) is on, the batteries are fully
charged for use. If the yellow light (E) or red light (D) is on,
batteries must be charged before operation. [Refer to
MENTAINENCE chapters for batteries charging]
3. Lower the squeegee assembly to the floor.
NOTE
Make sure the squeegee assembly is lifted before
the machine steer backward, or the Machine will
be stopped and LED screen show "Error"
information.
4. Lower the brush assembly to the floor.
NOTE
Make sure to turn off brush button before brush
assembly is lifted, and lift the brush assembly
before machine steers forward/backward.
5. Press brush button (B)
6. Depress the accelerate pedal (R), operate the
forward or backward by steering wheel (N) together with
forward-backward switch (H), you can adjust speed by speed
adjusting knob (I).
7. Adjust solution flow by solution adjusting button (G) base on
cleaning requirement.
8. You can charge your phone or pad through USB charging
port (M) when the key switch (A) is turned to "ON".
9. Press the horn button (F) to warn people when necessary.
10. If necessary, press the emergency button for machine
emergency stop.
NOTE
The brush motor, vacuum motor, drive motor and
control circuit are protected by overload protec-
tor (P).When the overload protector trip, do not
reset it immediately without finding out the root
cause, and make sure the motor is cooling-off
before reset.

Stopping the machine

11. Loosen the accelerate pedal (R, Figure 10), the machine stops running.
12. Press brush button (B) to stop brush motor.
13. Lift brush assembly (T) by depressing the pedal (Q).
14. Lift squeegee assembly (U) by squeegee lifting/lowering lever (O), and a few seconds later the vacuum system will
be closed.
Figure 9
D
E
F
G
H
machine
Figure 10
12
M
L
U T
ENGLISH
A
B
C
D
C
B
A
I
N
O
P
Q
R
S