Electric Connections - entrematic Ditec Traffic C Manuel D'installation, D'entretien Et D'utilisation

4. ELECTRICAL CONNECTIONS
4.1 Electrical panel
• Insert the cables with the pre-wired terminal boards in the housing. If not present, make a hole (drill with Ø 33 mm fig. 17)
and connect them to the boards (as shown in chap. 5). Fit the cables in the conduit and connect the connectors on the motor
(fig.18).
4.2 Electrical panel/motor/safety device connections
• Figure 19 shows the layout of the cables supplied and their position in the door; each cable is identified by a special code
on an adhesive label.
4.3 Safety photocells
• Make the electrical connections as shown in (fig.19).
• Make the connections in the control panel as shown in the diagrams in chap. 5.
Ø 33 mm
230 V
Inverter
TRAFFIC C
ENC M
400 V
400 V
Correctly size the line conductor cross-section by referring to the indicated absorption and taking the length and
installation of the cables into account.
17
F
400 V
0 1
Rx2
0 1
C T
Tx1
- 33 -
230 V
Inverter
A935G/E
0 1
Tx2
0 1
Rx1
7823C/D
7824C/D
7824C/D
0DT829 2016-04-01
EN
18
19