Parameter Reset - entrematic Ditec Traffic C Manuel D'installation, D'entretien Et D'utilisation

10 Opening ramp advance
11 Opening speed
in (Hz)
12 Closing speed
in (Hz)
13 Enable service alarms
14 Service thresh
Enable stop 1-2
15
16 Brake resistance
(default NO)
17

PARAMETER RESET

ONCE PROGRAMMING HAS ENDED, SET DIP2 TO OFF
0DT829 2016-04-01
by scrolling CHANGE VALUE
(1 unit ≅ 3mm)
or
to confirm
by scrolling CHANGE VALUE
or
to confirm
by scrolling CHANGE VALUE
or
to confirm
YES
by scrolling
or
to confirm
NO
by scrolling CHANGE VALUE
or
to confirm
YES
by scrolling
or
to confirm
NO
by scrolling YES
or
to confirm
NO
CONFIRM
by scrolling
or
to confirm
- 44 -
When the value increases, the
deceleration distance when opening
increases.
The setting of values that are higher
than the default ones must be assessed
according to door dimensions and
operating conditions.
The setting of higher values must be
assessed according to door dimensions
and operating conditions.
Option available only if YES has been
selected for point 14).
Set value to steps of 1000 cycles Max
200,000 cycles
If set to YES, opening of the contact
1-2 STOPS the door.
Set to YES when the door is supplied
with brake resistance.
Confirm to go back to the installation
menu.