Limit Switch Adjustment; Electrical Connections - entrematic Ditec CROSS30 Manuel D'installation Et D'entretien

3.5 Limit switch adjustment

- Manually position the door wing completely open and
fasten the limit switch brackets [17] onto the rack so that
the lever limit switch exceeds the bracket's length by
approximately 2/3. Repeat the operation with door wing
completely closed.
- Provide power and carry out some opening and closing
operations (see the starting instructions in the control panel
installation manual).
Adjust the limit switch bracket [17] so that the gate stops
approximately 20 mm before the opening and closing
stops.
A
OPENING
4.

ELECTRICAL CONNECTIONS

The electrical connections and starting are illustrated in the
installation manual of the E1T control panel.
yellow-green
responsibility for eventual errors, ommisions or incomplete data due to technical or illustrative purposes.
CROSS30 - IP1777
4.1
The automation is provided with opening to the right (automation
side view).
-
4.2
-
-
A
Disconnect the power supply and release the gearmotor (see
RELEASE/BLOCK operations):
-
-
Connect the power supply and block the gearmotor (see RELE-
ASE/BLOCK operations):
-
~20
-
-
-
6 . Disposal
regulations before proceeding.
The packaging materials must not be discarded in the environ-
ment or left within reach of children, as they are a potential
source of danger.
ies and accumulators correctly, take the product to the differ-
entiated disposal and recycling centres, respecting the regula-
tions in force.
12
Bring the gate to a central position and give an opening
command (1-3), check the motor opens to the right, other-
wise reverse two phases of the 400 V~ power supply.
Reverse the connection of the limit switch terminals on the
Bring the gate to a central position and give an opening
command (1-3), check the motor opens to the left, other-
wise reverse two phases of the 400 V~ power supply.
structure have suitable mechanical strength and are in
good condition.
Check the gate-gearmotor alignment, the distance (2-3
mm) between the throat of the pinion and the crest of the
rack.
Clean the wheel's sliding guide, the rack and pinion of the
gear motor and slightly lubricate the rack and pinion of the
gearmotor. Manually check that the gate slides evenly and
without friction.
Check that the limit switches are working correctly (the
gate should stop 20 mm before the stop).
Check the power adjustment.
Check that all control and safety functions are working
correctly.
The packaging components (cardboard, plastic, etc.) must
be separated out for recycling. Refer to the local disposal
To dispose of electrical and electronic equipment, batter-