Components; Correct Use - Meister MWS900-125 Traduction Du Manuel D'utilisation Original

5455200-Winkelschl_man 08.05.15 13:07 Seite 49
use of the machine may deviate from
the specification given in the operating
instructions or determined by the
manufacturer. This may be caused by
the following influencing factors that
should be taken into account prior to
and during each use:
• Is the device being used correctly
• Is the correct type of material being
processed
• Is the device in proper working order
• Are the handles or optional vibration
handles mounted and fixed securely
up against the body of the machine.
If your hands experience an unpleasant
sensation or the skin changes colour
whilst you are using the machine, stop
using the machine immediately. Take
sufficient breaks. If you do not take
sufficient breaks, this may lead to a
hand/arm vibration syndrome.
An estimate of the level of load in
conjunction with the work or use of the
machine should be carried out and
breaks set out accordingly. This method
can be used to considerably minimise the
level of load during the entire working
time. Minimise risks in which you are
exposed to vibrations. Take care of your
machinery in accordance with the
directions in the operation instructions.
If the machine is to be used frequently,
contact your dealer and arrange anti-
vibration equipment (handles) if necessary.
Avoid using the tool in temperatures of
t = 10 °C or lower. Draw up a working
schedule which can be used to
minimise vibration loads.
Information about minimising noise
A certain amount of noise is
unavoidable when using this device.
Ensure you carry out noise-intensive
work during permitted times.
Maintain the quiet periods and limit
your work to the absolute minimum.
For the sake of your personal protection
and the protection of persons in close
proximity, suitable ear defenders should
be worn.
3 – Components
1 On/Off switch mechanism
2 Handle
3 Disc cover for separating discs
4 Spindle with connection thread
5 Screw
6 Spindle locking button
7 Tensioning disc
8 Clamping nut
9 Toroidal coil (Figure 2)
10 Additional handle
11 Flange wrench
12 Disc cover for roughing discs
4 – Correct use
Use in accordance with the intended
purpose
An angle grinder is an electrically driven
hand-held device with a fast rotating
round grinding disc that is operated via
an angled drive.
Used as a grinder with the appropriate
grinding disc and protective hood, it is
possible to remove flash and to carry
out finishing work on materials of
various steel qualities, bronze and
aluminium.
When used as a separator with the
appropriate separating disc and
protective hood, cuts can be made in
steel, cement and stone.
49