Meister MWS900-125 Traduction Du Manuel D'utilisation Original page 52

5455200-Winkelschl_man 08.05.15 13:07 Seite 52
moving parts. Loose clothes, jewellery
or long hair can be caught in moving
parts.
g Keep handles dry, clean and free from
oil and grease. Slippery handles do not
allow for safe handling and control of the
tool in unexpected situations.
h If devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
52
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
II. Safety notes for all applications
General warnings with regard to
abrasive cutting and roughing:
a This electrical tool is to be used
as a grinder and cutting device.
Pay attention to all of the warning
notes, instructions, diagrams
and data you receive with the unit.
If you do not observe the following
instructions, it may lead to electrical
shock, fire and/or serious injuries.
b This electrical tool is not suitable
for sandpaper sanding, working
with wire brushes, polishing. Uses
for which the tool is not designed
may cause risks and injury.