Service And Maintenance - Renishaw TS27R Manuel D'installation Et D'utilisation

1-14
SERVICE
You may undertake the maintenance routines
described in this handbook.
Further dismantling and repair of Renishaw
equipment is a highly specialised operation, which
must be carried out at authorised Renishaw Service
Centres.
Equipment requiring repair, overhaul or attention
under warranty should be returned to your supplier.
O ring
Probe serial no.
TS27R PROBE MODULE

SERVICE AND MAINTENANCE

Spring
Front
cover
Metal eyelid
seal
Inner diaphragm
seal
MAINTENANCE
The probe is a precision tool and must be
handled with care.
Ensure the probe is firmly secured to its
mounting.
The probe requires minimal maintenance as it is
designed to operate as a permanent fixture on CNC
machining centres, where it is subject to a hot chip
and coolant environment.
1. Do not allow excessive waste material to build
up around the probe.
2. Keep all electrical connections clean.
3. The probe mechanism is protected by an outer
metal eyelid seal and an inner flexible
diaphragm seal.
Approximately once a month, inspect the probe
inner diaphragm seal. If it is pierced or
damaged, return the probe to your supplier for
repair.
The service interval may be extended or
reduced depending on experience.