Safety Instructions - CTC EcoMiniEl 1x230V Instructions D'installation Et D'entretien

English

Safety instructions

The installation should be preceded by an omnipolar safety switch according
to overvoltage category III, which ensures disconnection from all electric power
sources. Turn off the power with an omnipolar switch before doing any work on the
product.
The product must be connected to protective earth.
The product is classified as IPX1. The product must not be rinsed with water.
When handling the product with a hoist ring or similar device, make sure that the
lifting equipment, eyebolts and other parts are not damaged. Never stand under the
hoisted product.
Never jeopardise safety by removing bolted covers, hoods or similar.
Installation and connection in the boiler must be undertaken by an authorised
electrician. Electrical installation must be performed in compliance with specific
requirements in the national electrical safety standard.
Safety valve check:
EN
-Safety valve for boiler/system to be checked regularly.
The product must not be started if it is not filled with water; instructions are in the
"Pipe installation" section.
WARNING: Do not switch on the product if there is a possibility that the water in the
heater is frozen.
This device can be used by children from the age of three years and above and
by people with reduced physical, sensory or mental ability or lack of experience or
knowledge if they have been taught, either with supervision or with the instructions
provided, how to use the device safely and understand the risks involved. Children
should not play with the device. Cleaning and maintenance should not be carried
out by children without supervision.
If these instructions are not followed when installing, operating and maintaining the
system, Enertech's commitment under the applicable warranty terms is not binding.
36 CTC EcoMiniEl