Troubleshooting - Scheppach DP3000 Traduction Des Instructions D'origine

16. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Problem
Engine fails to start
Engine runs erratically.
Engine overheats.
Machine does not move while
engine is running.
34 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible Cause
Spark plug wire disconnected.
Out of fuel or state fuel.
Choke not in open position.
Blocked fuel line.
Fouled spark plug.
Engine flooding.
Spark plug wire loose.
Unit running on CHOKE.
Blocked fuel line or stale fuel.
Vent plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Improper carburetor adjustment.
Engine oil level low.
Dirty air cleaner.
Air flow restricted.
Carburetor not adjusted properly.
Gear is not properly selected.
Driving tracks not tight enough.
Remedy
Attach spark plug wire securely to spark plug.
Fill with clean, fresh gasoline.
Throttle must be positioned at choke for a cold
start.
Clean the fuel line.
Clean, adjust gap, or replace.
Wait a fes minutes to restart, but do not prime.
Connect and tighten spark plug wire.
Move choke lever to OFF.
Clean fuel line. Fill tank with clean, fresh gasoli-
ne.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Clean or replace air cleaner.
Consult the service.
Fill crankcase with proper oil.
Clean air cleaner.
Remove housing and clean.
Consult the service.
Ensure gear lever is not in-between two diffe-
rent gears.
Tighten driving tracks.