EUROM 333589 Mode D'emploi page 13

The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired!
Operation
Check for every use:
- or the appliance doesn't show signs of damage.
- Check whether the equipment is on a flat, level and vibration free surface
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz). Check
whether the socket is earthed and secured with a 30mA circuit breaker.
If everything is all right you can insert the plug into the socket.
During the first minutes of operation the device can emit a little smoke or odor.
This is normal and disappears after a few minutes. Doesn't it disappear, consult
your dealer.
Cleaning - service
Cleaning
Before cleaning remove the plug from the power outlet and wait until the appliance
is sufficiently cooled off.
Wipe the appliance only with a clean and lint-free cloth or a soft brush. Never use
abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning! Never use
flammable cleaners such as benzene or spirits. Give the appliance time to dry
before you use it again.
To protect against electrical shock and danger of life, do not immerse cord, plug or
any part of the appliance in water or other liquid.
Make sure no water gets into the heater when you clean it!
At the end of the season, store the cleaned heater in the original packaging if
possible. Store upright in a cool, dry and dust-free place.
Service
Repairs must be carried out by authorised specialists (dealer or electrician), thus
ensuring electrical safety.
Now you can switch on the machine by turning
the operating button to I (450W, half power) or
II (900W, full power). To turn the machine off,
you turn the button to 0 and remove the plug
from the socket. Allow the radiator time to cool.
13