Technical Data - Stiga SMT 48 AE Manuel D'utilisation

TECHNICAL DATA/DESCRIPTION/ASSEMBLY

3. TECHNICAL DATA

Pole saw
Input voltage
No-load chain speed
Max cutting length
Weight
Chain Oil tank capacit
Pole hedge Trimmer
Input voltage
No-load speed
Blade length
Blade gap
Blade brake time
Weight (without battery)
Vibration
4. DESCRIPTION
Features(Pole Saw)
1. On/off switch
2. Lock-off button
3. Main handle
4. Saw head
5. Sprocket cover
6. Guide bar
7. Chain
8. Chain sheath
9. Extension tube
10. Battery
11. Oil tank
12. Charger
.
Features(POLE Hedge trimmer)
25. On/off switch
26. Lock-off button
27. Main handle
28. Trimmer head
29. Blade
30. Blade sheath
31. Battery
32. Charger
33. Charging indicator
34 . Pivoting button
vdc 48
m/s 9.9 ±10%
mm 200
kg 3.8
ml 50
vdc 48
min- 1,200
1
mm 450
mm 18
s < 1.0
kg 4.25
5. ASSEMBLY (POLE SAw)
wARNING
Before assembly, remove the battery from the tool.
FITTINg AND REMOVINg ThE BATTERY (FIg.B)
■ To fit the battery(10), line it up with the receptacle
on the tool. Slide the battery into the receptacle and
push until the battery snaps into place.
■ To remove the battery, push the release button
while at the same time pulling the battery out of the
receptacle..
wARNING
To prevent accidental operation, ensure that the
battery is removed and that the chain sheath is in
placed on the saw chain before performing the
following operations. Failure to do this could result in
serious personal injury..
FITTINg ThE sAw hEAD (FIg C)
The saw head can be fitted directly to the handle in
order to achieve standard reach.
■ Align the groove on the outside of the coupling end
of the handle (3) with the tongue on the inside of the
coupling end of the saw head (4). Push the saw head
(4) onto the handle (3).
■ Slide the collar upwards and rotate it counter-
clockwise until it is fully tightened.
wARNING
Periodically check the connections to ensure that
they are tightened securely.
ExTENDING THE SAW HEAD (FIG.D)
The maximum reach can be achieved by fitting the
extension tube (9) between the saw head (4) and the
handle (3).
■ Align the groove on the outside of the coupling end
of the handle (3) with the tongue on the inside of the
coupling end of the extension tube (9).
■ Push the extension tube (9) onto the handle (3).
■ Slide the collar upwards and rotate it counter-
clockwise until it is fully tightened.
■ Align the groove on the outside of the coupling end of
the extension tube (9) with the tongue on the inside of
the coupling end of the saw head (4).
■ Push the saw head (4) onto the extension tube (9).
■ Slide the collar upwards and rotate it counter-
clockwise until it is fully tightened.
wARNING
Periodically check the connections to ensure that
they are tightened securely.
6
EN