Installation Check List; Additional Checks For Remote Models - Koolaire K Série Mode D'emploi

Section 2

Installation Check List


Is the Ice Machine level?

Have all of the electrical and water
connections been made?

Has the supply voltage been tested
and checked against the rating on the
nameplate?

Is there proper clearance around the ice
machine for air circulation?

Is the ice machine grounded and
polarity correct?

Has the ice machine been installed
where ambient temperatures will
remain in the range of 35° - 110°F (1.6° -
43.3°C)?

Has the ice machine been installed
where the incoming water temperature
will remain in the range of 35° - 90°F
(1.6° - 32.2°C)?

Is there a separate drain for the potable
water, bin and water-cooled condenser?

Are the ice machine and bin drains
vented?

Are all refrigerant lines free from
contact with other components?

Are all electrical leads free from contact
with refrigeration lines and moving
equipment?

Has the owner/operator been instructed
regarding maintenance and the use of
our Cleaner and Sanitizer?

Has the owner/operator completed the
warranty registration card?

Has the ice machine and bin been
sanitized?

Is the ice thickness set correctly? (Refer
to Operational Checks to check/set the
correct ice bridge thickness).
Part Number: 000014142 Rev 02 5/17
ADDITIO
AL CHECKS FOR REMOTE
MODELS

Does the remote condenser fan operate
properly after start-up?

Has the remote condenser been located
where ambient temperatures will
remain in the range of -20° - 120°F (-29
- 49°C).

Is the line set routed properly?

Are both refrigeration lines to remote
condenser run so they do not lay in
water and are properly insulated?
Installation
23