Safety Limit Feature - Koolaire K Série Mode D'emploi

Section 5
Problem
Low ice capacity.

Safety Limit Feature

In addition to the standard safety controls,
such as the high pressure cutout, your
ice machine features built-in safety
limits which will stop the ice machine if
conditions arise which could cause a major
component failure.
Refer to Safety Limits Section 3 for more
information on safety limits.
Part Number: 000014142 Rev 02 5/17
Possible Cause
The condenser is dirty.
High air temperature around
ice machine (air-cooled
models).
Inadequate clearance around
the ice machine.
Objects stacked around ice
machine, blocking airflow
to condenser (air-cooled
models).
Hot incoming water.
Incorrect incoming water
pressure. Water pressure
is too low or water filter is
restricted.
Before calling for service, re-start the ice
machine using the following procedure:
1.
2.
To Correct
Clean the condenser.
Air temperature must not
exceed 110°F (43°C).
Provide adequate clearance.
Remove items blocking
airflow.
Connect the ice machine to a
cold water supply.
Water pressure must
be 20-80 psi (137.9 -
551.5 kPa). Refer to Section 2
for plumbing requirements.
Replace water filter.
Move the toggle switch to OFF, then
the ICE position,
A. If the safety limit feature has
stopped the ice machine, it will
restart after a short delay. Proceed
to step 2.
B. If the ice machine does not
restart, see "Ice machine does not
operate" on page 37.
Allow the ice machine to run to
determine if the condition repeats.
A. If the ice machine stops again, the
condition has repeated. Call for
service.
B. If the ice machine continues to
run, the condition has corrected
itself. Allow the ice machine to
continue running.
Troubleshooting
39