Preventative Maintenance Cleaning Procedure; Door Removal; Cleaning The Condenser Filter - Koolaire K Série Mode D'emploi

Maintenance
Preventative Maintenance Cleaning
Procedure
This procedure cleans all components in
the water flow path, and is used to clean
the ice machine between the bi-yearly
cleaning/sanitizing procedure.
Ice machine cleaner is used to remove lime
scale and mineral deposits. Ice machine
sanitizer disinfects and removes algae and
slime.
NOTE: Although not required and
dependent on your installation, removing
the ice machine top cover may allow easier
access.
Step 1 Ice must not be on the evaporator
during the clean/sanitize cycle. Follow one
of the methods below:
• Move the toggle switch to the OFF
position at the end of a harvest cycle
after ice falls from the evaporator(s).
• Move the toggle switch to the OFF
position and allow the ice to melt.


Notice
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 Open the front door and move
the toggle switch to the CLEAN position.
Wait until the water trough refills
(approximately 1 minute) and then add the
proper amount of Ice Machine Cleaner to
the water trough.
Model
K0300 K0400 K0420
K0500 K0700 K1000
K1700
34
Amount of Cleaner
3 ounces (90 ml)
5 ounces (150 ml)
9 ounces (265 ml)
Step 3
After 1 minute place the toggle
switch in the ICE position and close and
secure the front door. The ice machine will
automatically start ice making after the
Clean cycle is complete (approximately 24
minutes).

Door Removal

1. Use a Phillips screwdriver to loosen
the two screws securing the door.
Do not remove, they are retained to
prevent loss.
2. Tilt door forward and lift up to remove.

Cleaning the Condenser Filter

The washable filter on self-contained ice
machines is designed to catch dust, dirt,
lint and grease. Clean the filter with a mild
soap and water.
Part Number: 000014142 Rev 02 5/17
Section 4