Air Baffle; Electrical Service - Koolaire K Série Mode D'emploi

Section 2

Air Baffle

Self-Contained Air-Cooled Only
To install:
1. Loosen the back panel screws next to
the condenser.
2. Align the keyhole slots in the air baffle
with the screw holes and slide the
baffle down to lock in place.
Part Number: 000014142 Rev 02 5/17

Electrical Service

All electrical work, including wire routing
and grounding must conform to all
applicable national and local electrical
codes.
Minimum Circuit Ampacity
The minimum circuit ampacity is used to
help select the wire size of the electrical
supply. (Minimum circuit ampacity is not
Air Baffle
the ice machine's running amp load.)
Electrical Requirements
Refer to Ice Machine Model/Serial Plate for
voltage/amperage specifications.
• A separate fuse/circuit breaker must be
provided for each ice machine.
• The wire size (or gauge) is dependent
upon location, materials used, length of
run, etc., so it must be determined by a
qualified electrician.
• The ice machine must be grounded.
Check all green ground screws in the
control box and verify they are tight
before starting the ice machine.
• The maximum allowable voltage
variation is ±10% of the rated voltage at
ice machine start-up (when the electrical
load is highest).
Observe correct polarity of incoming line
voltage. Incorrect polarity can lead to
erratic ice machine operation. Operate
equipment only on the type of electricity
indicated on the specification plate.
Installation
Warning
n



otice
13