Koolaire K Série Mode D'emploi page 31

Section 4
Step 1
Remove the front door to access
the evaporator compartment. Ice must
not be on the evaporator during the clean/
sanitize cycle. Set the toggle switch to
the OFF position after ice falls from the
evaporator at the end of a harvest cycle. Or,
set the switch to OFF and allow the ice to
melt off the evaporator(s).


Notice
Never use anything to force ice from the
evaporator. Damage may result.
Step 2 Remove all ice from the bin/
dispenser.
Step 3 Place the toggle switch in the
CLEAN position. Water will flow through
the water dump valve and down the drain.
Wait until the water trough refills, then add
the proper amount of ice machine cleaner.
Model
K0300 K0400 K0420
K0500 K0700 K1000
K1700
Step 4 Wait until the clean cycle is
complete (approximately 30 minutes). Then
disconnect power to the ice machine (and
dispenser when used).
n
Disconnect the electric power to the ice
machine at the electric service switch box.
Step 5 Remove parts for cleaning.
Please refer to parts removal and continue
with step 6 when the parts have been
removed - Refer to page 33.
Part Number: 000014142 Rev 02 5/17
Amount of Cleaner
5 ounces (150 ml)
9 ounces (265 ml)
Warning
Step 6
Mix a solution of cleaner and
lukewarm water. Depending upon the
amount of mineral buildup, a larger
quantity of solution may be required. Use
the ratio in the table below to mix enough
solution to thoroughly clean all parts.
Solution
Water
Type
Cleaner 1 gal. (4 L)
Step 7 Use 1/2 of the cleaner/water
mixture to clean all components. The
cleaner solution will foam when it contacts
lime scale and mineral deposits; once
the foaming stops use a soft-bristle nylon
brush, sponge or cloth (NOT a wire brush)
to carefully clean the parts. Soak parts for
5 minutes (15-20 minutes when heavily
scaled). Rinse all components with clean
water.
Step 8 While components are soaking,
use 1/2 of the cleaner/water solution
to clean all foodzone surfaces of the ice
machine and bin (or dispenser). Use a nylon
brush or cloth to thoroughly clean the
following ice machine areas:
• Evaporator plastic parts – including top,
bottom and sides
• Bin bottom, sides and top
Rinse all areas thoroughly with clean water.
Maintenance
Mixed with
16 oz (500 ml)
cleaner
31