Charging The Battery; Removing The Battery; Operation - Hilti HDE 500-A18 Mode D'emploi

6.2 Charging the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first
time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
Read the operating instructions for the charger for
further information about the charging procedure.
Li-ion batteries are ready for use at any time, even
when only partly charged. Charging progress is in-
dicated by the LED display (see charger operating
instructions).
6.3 Fitting the battery 3 4
CAUTION
Before inserting the battery, check that the dis-
penser output selector switch is in the "off" posi-
tion. Use only the Hilti batteries approved for use
with this power tool.

7. Operation

7.1 Further instructions for use
CAUTION
Risk of pinching your fingers! Keep your hands
clear of the cradle area when pivoting the foil pack
holder into position.
WARNING
Observe the information on the safety data sheets,
on the packaging and in the instructions for use
before using the product.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069911 / 000 / 00
CAUTION
Before inserting the battery in the tool or appliance,
check that the terminals of the battery and the tool
or appliance are free from foreign objects.
1. Push the battery into the tool from the rear as far
as it will go and until it is heard to engage with a
click.
2. CAUTION A falling battery may present a risk of
injury to yourself or others.
Check that the battery is seated securely in the
tool.

6.4 Removing the battery

1. Press both release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (work-
ing position) and move it into the first click-stop
position (transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts
of the battery pack are not short-circuited. Remove
loose metal parts such as screws, nails, clamps,
loose screw bits, wires or metal swarf from the case,
toolbox or transport container, or prevent these parts
from coming into contact with the battery packs.
Observe national and international transport regula-
tions when shipping battery packs (transportation by
road, rail, sea or air).
WARNING
Always set the dispensing mode selector switch
to the "0" (off) position before transporting or
storing the tool. This will prevent inadvertent battery
discharge or mortar ejection.
The tool begins to operate if the trigger is pressed
while the dispensing mode selector switch is in the
"dispensing" position. To prevent inadvertent opera-
tion causing battery drain or mortar being dispensed,
the dispensing mode selector switch must be left in
the "off" position during transport or storage.
en
7