Hilti HDE 500-A18 Mode D'emploi page 16

WARNING
Never point the tool toward yourself or other per-
sons.
WARNING
Begin dispensing mortar only after the mixing noz-
zle has been screwed on.
NOTE
The foil pack opens automatically when dispensing
begins. The two components can be seen to mix
inside the mixing nozzle.
1. Set the mode selector switch to "continuous
operation".
2. Press the trigger until the mixing nozzle is com-
pletely full.
3. Set the dispensing selector switch to the mortar
volume to be discarded (number of strokes) in
accordance with the instructions for use of the
mortar.
4. Discard this initial quantity of mortar dispensed.
7.6 Dispensing 10 11
WARNING
Never point the tool toward yourself or other per-
sons.
WARNING
Begin dispensing mortar only after the mixing noz-
zle has been screwed on.
CAUTION
The tool / foil pack must not be under pressure when
the mixing nozzle is changed.
NOTE
Mortar in the mixing nozzle hardens if dispensing is
interrupted for a long period. Screw on a new mixing
nozzle when you wish to continue dispensing mortar.
NOTE
Please refer to the instructions for use of the foil pack
for further information about use of the mortar.
NOTE
Store partly-used foil packs in the foil pack holder
with the mixing nozzle screwed on. Partly-used foil
packs have a limited shelf life. Please refer to the
instructions for use of the foil pack.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069911 / 000 / 00
7.7 Changing the foil pack 12 13 14
NOTE
All 4 LEDs on the battery blink briefly to indicate when
a foil pack is completely empty.
1. Press the release button and maintain pressure
on it.
2. Pull the piston rods all the way back.
3. Remove the foil pack holder from the tool by
tilting it slightly and applying light pressure from
below.
4. Grip the empty foil pack by the mixing nozzle and
pull it out of the foil pack holder.
5. Push a new foil pack into the holder as far as it
will go and screw on a new mixing nozzle.
6. Re-insert the foil pack holder in the tool, applying
light pressure until it clicks into place.
7.8 Disposing of a foil pack
CAUTION
Dispose of completely emptied foil packs in accor-
dance with nationally applicable instructions.
NOTE
For information about disposing of full, partly-used
and completely empty foil packs, please refer to the
instructions for use of the product or the applicable
safety data sheets.
7.9 Removing the foil pack holder from the
tool 15 16
1. Press the release button and maintain pressure
on it.
2. Pull the piston rods all the way back.
3. Remove the foil pack holder from the tool by
tilting it slightly and applying light pressure from
below.
4. Grip the foil pack holder by the large cylinder.
5. Keep the release button at the rear end of the foil
pack holder pressed in.
6. Disengage the foil pack holder from the rear
locating lug.
7. Pull the eye on the foil pack holder off the front
locating lug and remove the foil pack holder from
the tool.
en
9