Disposal; Manufacturer's Warranty - Hilti HDE 500-A18 Mode D'emploi

Fault
The foil pack cannot be tilted
and pushed down into the
tool.
en
The foil pack holder doesn't
engage with an audible click.

10. Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: The burning of plastic components
generates toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to
very high temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal
may permit unauthorized and improper use of the equipment. This may result in serious personal injury, injury
to third parties and pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt to open or
dismantle batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements
for taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative
for further information.

11. Manufacturer's warranty

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5069911 / 000 / 00
Possible cause
The foil pack is not pushed fully
into the holder.
The piston rods are not pulled back
fully.
The retaining catches are dirty /
clogged.
The retaining lugs are defective.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Remedy
Push the foil pack into the holder
as far as it will go.
Press the release button and pull
the piston rods back as far as they
will go.
Clean the retaining catches and
engage the foil pack holder fully.
Fit another foil pack holder.
Contact Hilti Service if the problem
persists.