Hilti HDE 500-A18 Mode D'emploi page 15

Use of genuine Hilti parts ensures maximum safety.
The dispenser, the foil pack holder and the foil packs
are perfectly matched to each other.
The tool will achieve high performance, high bat-
tery capacity and long life if handled carefully and
en
maintained correctly.
IMPORTANT! The motor cut-out will be activated if
the tool is overloaded. The tool relieves pressure
automatically and is subsequently ready for further
operation.
7.2 Dispensing mode selector switch positions
NOTE
The volume to be dispensed cannot be adjusted while
the trigger is pressed.
7.2.1 "0" (off) position
The tool is switched off.
No mortar can be dispensed.
7.2.2 Volume settings 1 to 15
NOTE
The volume settings required may vary according to
foil pack type and temperature. The values given here
are to be used as a guide.
1. Select the required volume.
1 = 1 stroke (approx. 5 ml (0.17 fl.oz.))
15 = 15 strokes (approx. 75°ml (2.55 fl.oz.))
2. Press the trigger and maintain pressure on it
until the tool stops automatically after ejection of
the selected volume.
7.2.3 Switch position for sustained operation
1. Press the trigger to begin dispensing and control
the flow rate.
Increase pressure on the trigger to increase the
flow rate and reduce pressure to reduce the flow
rate.
2. Release the trigger when you wish to interrupt
or stop the dispensing operation.
Pressure on the foil pack is released automat-
ically so no further mortar escapes from the
mixing nozzle.
7.3 Selecting the foil pack holder 2
CAUTION
Check the foil pack holder for damage and/or soil-
ing. Both pistons must move smoothly and easily in
both directions over the full length of their travel in
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5069911 / 000 / 00
the foil pack holder. Damaged and/or badly soiled
foil pack holders must be replaced.
NOTE
Foil pack holders are available as accessories.
Select the correct foil pack holder according to the
color of the foil pack.
Black foil pack holder: BLACK or WHITE foil pack
Red foil pack holder: RED foil pack
7.4 Inserting the foil pack in the foil pack
holder 5 6 7 8 9
NOTE
Follow the instructions for use of the foil pack.
WARNING
Check the foil pack for damage. Never use damaged
foil packs.
1. Press the release button and maintain pressure
on it.
2. Pull the piston rods all the way back.
3. Remove the foil pack holder from the tool by
tilting it slightly and applying light pressure from
below.
4. Grip the tool with the foil pack holder from the
side with one hand and push the foil pack into
the holder from the front, as far as it will go.
5. Screw the mixing nozzle all the way onto the foil
pack.
6. Insert the foil pack holder with the foil pack
into the tool, tilting it slightly and applying light
pressure until it clicks into place.
7.5 Discarding the initial quantity of mortar
dispensed 10 11
CAUTION
The initial quantity of mortar dispensed is not suit-
able for use. The quantity to be discarded is product
specific and is indicated in the applicable instruc-
tions for use. The initial quantity must also be
discarded after changing a mixing nozzle.