Symbols On The Product; Product Information; Safety Instructions - Hilti HAT 28 Mode D'emploi Original

1.3 Product-dependent symbols
1.3.1

Symbols on the product

The following symbols can be used on the product:
Wear a hard hat
Wear eye protection
Wear protective gloves
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Pull-out tester
Generation
Serial no.
2 Safety
2.1

Safety instructions

Basic information concerning safety
WARNING! Read all safety precautions and other instructions.
instructions and other instructions can result in damage to the tool and/or serious injury.
Keep all safety precautions and instructions for future reference.
Proper preparation of the working area
▶ Keep your workplace clean and well lit. Cluttered or poorly lit workplaces invite accidents.
▶ Wear personal protective equipment and always wear protective goggles.
▶ It is recommended that rubber gloves and non-skid shoes are worn when working outdoors.
▶ Keep children clear. Keep everyone clear of your work zone.
▶ When working on walls or ceilings, make sure that the surrounding work area is secured. Falling objects
or tools could cause serious injury.
▶ Avoid unusual body positions. Maintain firm footing and balance at all times. This will give you better
control of the product in unexpected situations.
General safety measures
▶ Use product, accessories, insert tools, etc. in accordance with these instructions. Take the working
conditions and the work to be performed into account. Use of equipment for applications other than
those intended can result in hazardous situations.
▶ To reduce the risk of injury, use only genuine Hilti tools and accessories.
Requirements to be met by users
▶ Follow the instructions concerning care and maintenance.
▶ Never tamper with or modify the power tool in any way.
▶ The tool is intended for professional use. The tool may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must be specially informed of any possible hazards.
▶ Do not operate the machine if your full attention is not on the job.
*286175*
286175
HAT 28
01
Failure to observe the safety
English 9