Filling With Consumables; Cooling Water - Struers Prepamatic-2 Mode D'emploi

Filling with Consumables

Cooling Water

Prepamatic-2
Instruction Manual
Before Prepamatic-2 can be used, the different consumables
required for the preparation have to be loaded.
Water from the Recirculation Cooling Unit is used for cooling and
lubrication when grinding on the first position.
To fill the Recirculation Cooling Unit:
Open the door at the front of Prepamatic-2.

Pull out the "drawer" with the Recirculation Cooling Unit.

Place a disposable plastic insert (see Accessories, section 5) in

the tank and fold it over the rim.
Fill the tank with 29.1 water and 900 ml Struers Additive.

The water level should be about 7 cm below the upper rim of the
tank.
Always maintain the correct concentration of Struers Additive in the cooling
water (percentage stated on the container of the Additive). Remember to
top up with Struers Additive each time you refill with water.
IMPORTANT
5