Connecting Prepamatic-2; Connection To Water Outlet; Connection To Water Supply; Connection To Compressed Air - Struers Prepamatic-2 Mode D'emploi

Connecting Prepamatic-2

Connection to Water Outlet

Connection to Water Supply

Connection to Compressed Air

Prepamatic-2
Instruction Manual
All the connections for Prepamatic-2 are located on the back of the
machine.

Water outlet

Water inlet

Compressed air

Electrical connection box
Connect the large outlet tube to the pipe marked "Water Outlet" on
the back of Prepamatic-2. Lead the tube to the drain. Make sure that
the tube slopes evenly downwards to prevent dirt from settling and
blocking the tube.
Connect the water inlet hose to the threaded pipe marked "Water
Inlet" on the back of the machine. Connect the other end of the tube
to the water tap.
Do not forget to insert the two filters in the connecting tube. If the water
installation is new, flush thoroughly before connecting Prepamatic-2.
Water pressure: min. 1 bar, max. 10 bar
Mount the hose nipple on the pressure hose and secure with the

12 mm hose clamp.
Connect the hose nipple to the inlet marked "Compressed Air".

Connect the other end of the pressure hose to the compressed

air supply. Air pressure: min. 5.0 bar, max. 9.9 bar.
IMPORTANT
3