Lubricant; Pre-Dosing; Mode; Direction - Struers Prepamatic-2 Mode D'emploi

Lubricant

Pre-dosing

Mode

Time
Removal
Removal/Time

Direction

34
Prepamatic-2
Instruction Manual

Pressing ENTER
lubricants available
It is only possible to select lubricant if the surface chosen is one with
a non-abrasive surface. Otherwise water will be selected
automatically.

Pressing ENTER
and 30 seconds.

Pressing ENTER
modes.
The preparation time can be specified in both a main and a final
phase. Usually the main phase is used to remove a large amount of
material, by using high forces and longer times, whereas the final
phase is used to improve the scratch pattern by applying lower
forces for a short while at the end of the preparation step.
When using a defined removal, only the main phase is active. The
force is kept constant to ensure that the specified amount of material
is actually removed.
A combination of the above. First a specified amount of material is
removed using a relatively high force. Thereafter the specimens are
run for a short while at a low force to improve the scratch pattern.
The direction of rotation of the specimen mover can be set to either
co- (>>) or counter (><) rotation. Co-rotation will give the best
preparation result and the most uniform polishing. Counter-rotation
can be used when polishing using oxide polishing suspensions to
keep the suspension on the polishing cloth.
allows you to select between the different
allows you to adjust the pre-dosing between 0
allows you to select between the 3 different