Nonin GO2 Guide D'utilisation page 8

Cautions
!
• Do not use the GO
only to be used as additional information that you can give to your licensed
health care professional.
• The GO
might misinterpret excessive movement as good pulse strength. Limit finger
2
movement as much as possible when using the device.
• The GO must be able to measure your pulse properly to give you an accurate reading.
2
Do not put the device on the same hand/arm when using a blood pressure cuff or monitor.
• The GO has no alarms. It will not sound if the amount of oxygen in your blood is low
2
or if your pulse rate is too high or too low.
• Do not place the GO
isopropyl alcohol, or products that are not listed in this User's Guide.
• The GO is not intended for use in institutions.
2
• Any of the following conditions may reduce the performance of the GO
- flickering or very bright light;
- weak pulse quality (low perfusion);
5
as the only basis for making medical decisions. It is intended
2
in liquid or clean it with agents containing ammonium chloride,
2
:
2