Technical Information; Environment Concerns - Zanussi ZDI16003XA Mode D'emploi

aid together with the combi detergent tab-
lets.
Refer to 'HINTS AND TIPS' for other pos-
sible causes.
Activating the rinse aid dispenser with the
multitab option activated
1. Press the on/off button to activate the appli-
ance. The on/off indicator comes on. Make
sure that the appliance is in setting mode,
refer to 'SETTING AND STARTING A
PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators above
function buttons (A), (B) and (C) start to
flash.
3. Press function button (B) .

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.

Environment concerns

The symbol on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
28
4. Press function button (B) to change the
5. Deactivate the appliance to confirm the set-
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
please contact your local council, your
household waste disposal service or the shop
where you purchased the product.
• Discard correctly the packaging material. Re-
• The indicators above function buttons (A)
and (C) go off.
• The indicator above function button (B)
continues to flash.
• The display shows the setting of the rinse
aid dispenser.
setting.
ting.
2)
cycle the materials with the symbol
Off
On
596 / 818 - 898 / 570
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
0.99 W
0.1 W
.
www.zanussi.com