Zanussi ZDI16003XA Mode D'emploi page 24

• The indicators of the 2 programme buttons
come on.
• The display shows 2 horizontal status bars.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. To set a programme, keep the appliance
door ajar.
3. Press the on/off button to activate the appli-
ance. The on/off indicator comes on.
4. Make sure that the appliance is in setting
mode.
5. Press one of the programme buttons again
and again until the number of the pro-
gramme you want to set flashes in the dis-
play.
• The phase indicators of the set pro-
gramme flash.
6. Close the appliance door. The programme
starts.
• The display shows the programme dura-
tion that decreases with steps of 1 mi-
nute.
• The indicator of the phase in operation is
on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until
the display shows the delay time you want
to set (from 1 to 19 hours).
• The delay time flashes in the display.
• The delay indicator comes on.
3. Close the appliance door. The countdown
starts.
• The display shows the countdown of the
delay start that decreases with steps of 1
hour.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the pro-
gramme starts.
24
– The delay indicator goes off.
– The indicator of the phase in operation
comes on.
– The display shows the programme dura-
tion.
You can set a programme, options and the
delay start also with the appliance door
closed. In this condition, you only have 3 sec-
onds after each setting before the appliance
starts to operate.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance contin-
ues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press and hold function buttons (B) and (C) at
the same time, until the indicators of the 2 pro-
gramme buttons come on and the display
shows 2 horizontal status bars.
When you cancel a delay start, the appli-
ance goes back to setting mode. You have
to set the programme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at
the same time, until the indicators of the 2 pro-
gramme buttons come on and the display
shows 2 horizontal status bars.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, the end in-
dicator comes on and the display shows 0.
1. Press the on/off button to deactivate the
appliance. The on/off indicator goes off.
2. Close the water tap.
www.zanussi.com