Technical Information - Zanussi ZDT16017FA Notice D'utilisation

rinse aid together with the combi detergent
tablets.
Refer to 'HINTS AND TIPS' for other pos-
sible causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to "Setting and starting
a programme".
2. Press and hold, at the same time,
until the
start to flash.
3. Press
.

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
Rating plate
26
, and indicators
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
• The
• The
• The display shows the current setting.
4. Press
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
and
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
2)
and indicators go off.
indicator continues to flash.
Rinse aid dispenser off.
Rinse aid dispenser on.
to change the setting.
596 / 818 - 898 / 555
(0.5 / 0.05 ) / (8 / 0.8 )
www.zanussi.com
220-240 V
50 Hz
max. 60 °C
12
0.99 W
0.10 W