Winterizing Your Unit; Self Help - Thermador DWHD630IFM Guide D'utilisation Et D'entretien

To avoid injury, do not reach into the large object trap with your fingers. The large
object trap could contain sharp objects.
To remove the Large Object Trap, remove the bottom rack. Grasp the assembly
and turn it counterclockwise. Lift the assembly out.
Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
upside-down and gently tap it on a flat surface to dislodge and remove debris.
Remove the Micro Filter as shown in Figure 12.
Flush the Micro Filter and Fine Filter clean by holding them under running water.
To reinstall the filter system, return the Micro Filter to the installed position. Place the Large Object
Trap/Cylinder Filter Assembly and Fine Filter into the installed position. Turn the locking nut clock-
wise until it is locked. The arrow on the ring handle and the arrow on the Fine Filter should point at
each other.
Clean the exterior door panel
Colored doors: use only a soft cloth dampened with soapy water.
Stainless steel doors: use a soft cloth with a non-abrasive cleaner (preferably a liquid spray) made
for cleaning stainless steel. For the best results, apply the stainless steel cleaner to the cloth and
then wipe the surface.
Clean the door gasket
Regularly clean the door gasket with a damp cloth to remove food particles and other
debris. Also clean the door seal, located inside the dishwasher at the bottom of the
door.

Winterizing your unit

If your dishwasher will be unused for an extended period of time in a location that
experiences freezing temperatures (holiday home or through a vacation period), have
your dishwasher winterized by an authorized professional service. Turn your household
water supply to the dishwasher off when on extended vacation or when dishwasher
will not be used for more than 1 month.

Self Help

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following
information may help you with a dishwasher problem without involving an authorized repair professional.
Problem
1. Door may not be properly latched
2. Unit may not be turned on
3. Unit not reset or previous cycle not completed
4. Delay start engaged
Dishwasher does
5. Interruption of electrical power supply to dishwasher
not start
or blown fuse
6. The door may have been closed without first select-
ing a cycle
7. Water supply may not be turned on
Dishwasher beeping 1. Default factory settings alert the customer that the
(end of cycle signal) cycle is complete by beeping. This feature can be deac-
tivated if so desired
Display does not 1. A fuse may have been blown or circuit breaker
illuminate tripped
2. Door not closed or latched
Note: For models with controls on top of the door, the
display only illuminate when the door is opened and
controls are visible.
CAUTION
Cause
1. Shut the door completely until you hear it click
2. Press the main power switch to turn unit on
3. To reset, refer to "Cancel a Cycle" (page 11) in this manual
4. To reset, refer to "Delay Start" (page 11) section in this manual
5. Check circuit breaker
6. Select a cycle and close the door
7. Check and turn on water supply
1. To adjust the volume or deactivate, refer to the "Cycle Completion
Signal" (page 12) section in this manual
1. Check the fuse or circuit breaker box and replace the fuse or reset
the breaker if necessary
2. Ensure door is properly latched and completely closed
Large Object
Trap
Cylinder
Fine Filter
Figure 11
Figure 12
Micro Filter
Action
Filter
13