Care And Maintenance - Thermador DWHD630IFM Guide D'utilisation Et D'entretien

Interrupt a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the On/Off button to turn the unit off.
3
Wait at least 10 seconds before fully opening the dishwasher door.
4
To resume the cycle, press the On/Off button and close the dishwasher door.
Added heat for drying:
1
Press and hold the Auto button, then press and hold the On/Off button.
2
When the LED display window indicates a "0" or "1" release both buttons.
3
To activate the added heat for drying, press the Auto button until the display indicates "1".
4
To disable the added heat for drying, press the Auto button until the display indicates "0".
5
Press the On/Off button to save the setting.
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the dishes. You
can choose to disable the tone or adjust the volume. The dishwasher must be powered OFF before adjusting the signal.
To activate:
1
With the unit OFF, press and hold the right of the two Cancel Drain buttons and then press and hold the On/Off button.
2
When the light on the Cancel Drain button you are pressing illuminates and the tone goes off, release both buttons.
3
Press the right of the two Cancel Drain buttons again until you achieve the desired volume or until there is no tone (to
turn cycle completion signal OFF).
4
Press the On/Off button to save the setting.

Care and Maintenance

Maintenance Tasks
Certain areas of the dishwasher require occasional maintenance. The maintenance tasks are easy to do and will ensure con-
tinued superior performance from your dishwasher.
Wiping up spills and splash-outs
Water may occasionally splash out of your dishwasher, particularly if you interrupt a cycle or open the dishwasher door dur-
ing a cycle. To avoid floor damage and possibly mold growth, do not allow wet areas to remain around or under the dish-
washer.
Clean the stainless steel inner door and tub
Clean the outer edges of the inside door panel regularly to remove debris that may collect from
normal loading. If spots begin to appear on the stainless steel, make sure the rinse aid is full and
functioning properly.
Check and clean spray arm nozzles
Remove the top spray arm by first removing the empty top rack from the dishwasher. Turn the rack
upside down. The top spray arm is held in position by a locking nut as shown in Figure 9. Turn the
locking nut counterclockwise and remove it to release the spray arm. Look for obstruction in the
spray nozzles. If the spray nozzles need cleaning, flush them under running water.
To reinstall the top spray arm, place it back in position and return the locking nut to its install posi-
tion. Turn the locking nut clockwise to secure. Return the top rack to the top rack roller guides.
Remove the bottom spray arm by first removing the empty bottom rack from the dishwasher.
Grasp and lift the spray arm as shown in Figure 10. Look for obstruction in the spray nozzles. If the
spray nozzles need cleaning, flush them under running water.
To reinstall the bottom spray arm, return the bottom spray arm to the installed position and press
it until it snaps into place. Return the bottom rack to the installed position.
Check and clean the filter system
The filter system consists of a Large Object Trap/Cylinder Filter assembly, a Fine Filter and a Micro
Filter. The filter system is located on the inside of your dishwasher under the lower rack and is eas-
ily accessible. During normal use, the filter system is self-cleaning. You should occasionally inspect
it for foreign objects and clean it when necessary.
12
Figure 9
Figure 10