Troubleshooting; Maintenance; Saw Replacement; Warranty - CombiSteel 7054 Série Mode D'emploi

TROUBLESHOOTING

Fault
The appliance is not
operating
The appliance makes
abnormal sounds
Lack of power supply

MAINTENANCE

The regular maintenance consists of saw replacement. To learn saw replacement look at below information.

SAW REPLACEMENT

Set the saw so the cutters face beneath. Pay attention to this point when installing
The service life of the appliance depends on utilization frequency. Replace the saw once it is blunt. Stoop the
appliance and pull the plug from the socket to replace the saw.
• Turn the strut anti clockwise to loosen the saw.
• Loosen the struts to open the cover.
• Use protective tools to extract old saw.
• Set the new saw on pulleys, close the cover.
• Turn the strut clockwise to fix the saw.

WARRANTY

7054 Series Bone Saw Machines are under warranty for 1 year against manufacturing defects of machines
covering defects in the goods, hidden defects in workmanship and/or hidden defects in material. Warranty is
invalid in case of failure due to violating rules specified in operation instructions. Combisteel BV is not responsible
for any damage or loss that may occur due to operational fault.
Combisteel BV, reserves the rights to change any products without notice. Technical data, drawings, scales,
working capacities and illustrations for informative purposes only. The manufacturer shall not be liable for any
typographical errors that may occur.
Possible cause
The plug may not be connected
The plug may be connected but the
emergency stop button may be
activated
The plug may be connected but the
start button may not be pressed
The cover may left open
The appliance settled on uneven
surface
The plug may be connected
improperly
The contactor makes sound
Plug cable may be torn and/or there
may be lack of phase
new saw. It is important for normal operating conditions.
www.combisteel.com
Actions to be taken
Connect the plug to power supply
Turn the emergency stop button in
direction of arrow labelled on the
button
Press Start button to start the
appliance
Close the cover, use pressing bars to
tighten the cover
Set the appliance on level ground or
provide stability via adjustable braces
Check the plug and correct if necessary
Restart the appliance
Open the cable and check if there is
any fault if necessary
9