Operating the Walkie−Talkies
4 Operating the Walkie−Talkies
Display and notation of operating sequences
P
a, P
b, P
[ y ]
ð
Switching the walkie−talkie on/off
a M
a M
Volume control
V
Transmitting and receiving
Transmitting
33
After pressing the P button, the Ready LED lights up.
If the P button is pressed longer than 60 seconds, a warning si-
gnal is issued. Transmission is interrupted.
a, P, ð
Receiving
34
b, P
60
An acoustic signal is issued. The current channel setting
appears in the display.
Hold the walkie−talkie approx. 5 to 7 cm from your mouth
and speak at a normal volume. In order to talk to other sub-
scribers, the respective walkie−talkies must be set to the
same channel and CTCSS code.
Radio signals cannot be received when the P button
is being pressed.
Press the button displayed
Press and hold the button displayed
Release the button displayed
Display indicator
Speak into the microphone
32
Switch the walkie−talkie on
Switch the walkie−talkie off
Increase (+) or decrease (−) the
volume
Transmit
Receive