Operating The Walkie−Talkies - switel WTF732 Mode D'emploi

3 x M
+/, P
An exception here is CTCSS/DCS code 0 (zero). When this setting is set, all
calls made on the channel set can be heard. In order to participate in the ra-
dio communication, you must set the corresponding CTCSS/DCS code.
Monitor function
The Monitor function enables the search for weak signals on the channel currently
set. If you receive an external signal, switch to a free channel. Always communicate
with other subscribers on a free channel to prevent interference.
a M and ,
M
1
VOX (handsfree)
With this function, the walkie−talkie begins to transmit automatically on detecting a
voice or a sound without the P button being pressed.
When you start to speak, there is a slight delay before the walkie−talkie starts
to transmit.
Activating VOX mode
4 x M
+
+/,
P
There are three sensitivity levels available for operation in VOX mode and can be se-
lected according to the ambient noise.
1
Loud ambient
noise
1
VOX: Voice Operated Transmission = Activation on detecting a sound
Operating the Walkie−Talkies
Activate the DCS code programming mode
Select the DCS code and confirm it
Monitor the channel
End monitoring
Select VOX mode
Open the VOX settings
Select the sensitivity
Confirm the selection
2
Normal ambient Low ambient
noise
3 OF
VOX
noise deactivated
59